Category Archives: Boat

The hull repairs might be done next week.

Posted on June 23, 2013 by Chris

I dropped by Hurliman Friday to see how things were going. They are welding up the fuel tank and finishing up Cabin Bilge compartment redo. I added that to the list of repairs recently. From the factory the compartment was … Continue reading →

Posted in Boat, Sea Ray | Leave a comment

Getting closer

Posted on July 8, 2012 by Chris

Well I shot my first small batch of gel coat on a deck panel that had twenty three holes in it. I only shot about seven holes this time. Other than the fact it set up almost immediately in 100 … Continue reading →

Posted in Boat, Sea Ray | Leave a comment

Swim Step Done

Posted on June 24, 2012 by Chris

Kinda. I have to pull it off to put the motor back in and also to do the fiberglass repairs. Argh! It will be sweet though once the boat is back in the water. I also have to remount he … Continue reading →

Posted in Boat, Family, Sea Ray | Leave a comment

So much for progress

Posted on June 10, 2012 by Chris

Well after my good progress yesterday, I hit a snag. I continued installing the stainless steel support tubes and I wrecked two pipe cutters. One cut then the cutting wheel crumbled, twice. I need to pick one up that has … Continue reading →

Posted in Boat, Sea Ray | 1 Comment

Progress on swim step

Posted on June 9, 2012 by Chris

Well I finally started mounting the swim step today. I made decent progress and hope to have it mounted tomorrow. Once that is done I have to pull it off to seal all the holes properly. At least everything will … Continue reading →

Posted in Boat, Sea Ray | Leave a comment